I have a situation in which I have a site where all the APs are not in the same subnet and thus the IP Addresses received by my clients are different. However, all APs are advertising the same SSID which is permitting roaming at the lower layers. Is there a configuration I can apply to the Access Points that will allow for clients to roam across SSIDs in a different subnet and get a new IP address without doing a ipconfig /renew or disabling and or enabling the wireless?
While in most sites I have them in the same subnet there is a site where they are in 2 subnets. I was hoping to be able to make the roam seamless. If you have to disable and enable the wireless or perform an ipconfig /renew it takes away from the seamlessness :-).
Any suggestions would be welcome. However, I can understand what Scott is saying also as that is how it currently works.
The environment consists of all Anonymous AP various Aironent 1200 series, i.e. 100, 1250, etc.
We are moving! Please use WLCCA Forum for updates and discussions
[toc:faq] Wireless LAN Controller (WLC) Config Analyzer Download Click
here to Download To request access, send an e-mail to
email@example.com. Please include your Cisco.com userna...
[toc:faq] IntroductionHere is the step by step process that we have to
take care of while converting LWAPP to IOS and then vice versa..LWAPP to
IOSThe hardware used = 1141 AP (make sure we are using the right
[toc:faq] Introduction AnyConnect Secure Mobility Client 3.0: Network
Access Manager & Profile Editor on Windows Summary Use the Cisco
AnyConnect Network Access Manager Profile Editor to build custom
profiles for the AnyConnect Secure Mobility Client. App...