Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Static IP Address Aironet 1200 - Controller 4002

Hi!

I have a 1200 series LWAPP. It has the default configuration which means it has configured the static IP address 10.0.0.1.

How can I change the address or how can the AP discover the controller address?

Ana

1 REPLY
Bronze

Re: Static IP Address Aironet 1200 - Controller 4002

Connect to the console and enter exec mode.

When the access point is running LWAPP or a recovery IOS image, you can configure the static IP address on the access point, the IP address of the controller, the access point hostname, and the default gateway IP address by entering these commands:

lwapp ap ip address ip-addr subnet-mask

lwapp ap controller ip address ip-addr

lwapp ap hostname ap-hostname

lwapp ap ip default-gateway ip-addr

The access point with a recovery IOS image uses the static controller IP address to register to the specified controller and download the current LWAPP image. After the access point successfully registers to the controller, it receives configurations from the controller. The access point static hostname and the IP address of the controller are deleted from the access point configuration file. However, the access point static IP address and the netmask and the default gateway IP address are not deleted.

348
Views
0
Helpful
1
Replies