Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Status of dot11Radio is "reset"

What is the reason that interface dot11Radio0 may have all time status "reset"?

AP is working as WGB, here is config:

http://docs.google.com/View?docid=dfq5mkqd_4frdrvphj

Thanks and regards,

4 REPLIES
Silver

Re: Status of dot11Radio is "reset"

Make sure the interface status of the Radio is Enabled. Go to Network Interfaces --> Dot11Radio0 -> Go to settings Tab and enable the interface. Make sure atleast one SSID is enabled.

New Member

Re: Status of dot11Radio is "reset"

I`m sure that interface and ssid is up

New Member

Re: Status of dot11Radio is "reset"

How is the inline power provided, with injector or from the switch port ? With injector you should it configure with the mac-address, saw this problem on 2950 switches that cn not provide the power.

New Member

Re: Status of dot11Radio is "reset"

AP is power from injector, but WGB is power from power supply. Interface of AP is OK, i have problem with interface of WGB, all time status is "reset" :/

486
Views
0
Helpful
4
Replies