Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Syslog server for access points

Hello,

On the controller, when you look at an access points config. There is the syslog server for the access point with the default ip address of 255.255.255.255. I was wondering if there was any way to disable the syslog server for the access points. The only thing I've found so far is that the ip address of the syslog server can be changed.

Thanks,

2 REPLIES
Silver

Re: Syslog server for access points

To remove a syslog server, use the no logging host global configuration command, and specify the syslog server IP address. To disable logging to syslog servers, enter the no logging trap global configuration command.

Re: Syslog server for access points

i am not sure if "no" command works.

but on 5.2 ver

config logging trap disable global

disbale/ enable is the key to set the ip address for syslog server

173
Views
0
Helpful
2
Replies