We are running a lot of BRI340(11Mbs 1/2 Duplx) wireless bridge links with multihops i.e repeater sites.We use the same unit all the way through.The two units at rptr site is connected with crossover utp >o.5m.Supposed Throughput is 4.5Mbs but testing with L7 tester(Q-check) throughput is halved with every repeater hop.why is this and can you get 4.5Mbs
Are the Bridges as the repeater site on the same channel/frequency? If you 2 bridges at each repeater site, connected with a cross over cable, and set to operate at different channels (use 1,6 or 11) and the antenna separated by several feet, you should be able to get full throughput. If you are using identical channels, or channels that with less than 5 channel separation, or have antenna located very close together, this can cause interference between the two bridges, reducing throughput.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...