Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Time problems

I keep getting this message whenever I boot my WLC. I have the Date and Time set correctly but I'm not sure how to set the timezone. Timezone options are Delta: hours __ minutes__

Daylight Savings Enable or disable

The message I keep getting is this:

"Controller time base status - Controller is out of sync with the central timebase."

5 REPLIES
Silver

Re: Time problems

For timezone here are 2 examples:

If you are in Arizona (no daylight savings time so always GMT -7)

config time timezone disable -7 0

If you are in New York (-5 or -4 during DST)

config time timezone enable -5 0

-Eric

Please remember to rate all helpful posts.

New Member

Re: Time problems

Thanks, got that set to my U.S. CST time. Now if I could just figure out why I keep getting the error message, because I don't have a "Central Timebase"???

New Member

Re: Time problems

anyone?

Blue

Re: Time problems

This looks like a radio problem, rather than a time zone problem. Open a TAC case and see what they say.

New Member

Re: Time problems

I'm running a WLC 2006 and 6 Aironet 1242's in lightweight mode. WLC is on the latest version and I've gotten this error with past two versions I have tried as well.

438
Views
10
Helpful
5
Replies