Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Too Many Stations in BSS

After upgrading a 340 to 12.01T the internal radio doesn't associate with the parent and the error message "Too many stations in BSS" keeps scrolling on the AP console. What is it trying to tell me?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Too Many Stations in BSS

Please see this field notice

http://www.cisco.com/warp/public/770/fn15790.shtml

If you match all of these symtoms then your AP will require an RMA if covered by warranty or contract

4 REPLIES
New Member

Re: Too Many Stations in BSS

I've also discovered that under Setup/Role in Radio Network, the only option is "Site Survey Client". Of course, as the help says, this doesn't allow any clients to associate with the AP.

New Member

Re: Too Many Stations in BSS

And the Status of awc0 on the Client Radio Port page says "no link" Why? Everything has been set to defaults.

Cisco Employee

Re: Too Many Stations in BSS

Please see this field notice

http://www.cisco.com/warp/public/770/fn15790.shtml

If you match all of these symtoms then your AP will require an RMA if covered by warranty or contract

New Member

Re: Too Many Stations in BSS

And what happens if it is too old for warranty and not under contract?

P.S. Thanks for the post. I figured it out and found this same field notice about noon on Friday.

117
Views
0
Helpful
4
Replies