Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trashed Firmware on WLC 2006

I was doing an update on a 2006 WLC and after i uploaded the firmware and everything finished fine i saved the config and rebooted. Now i will not boot up and I cannot get into the Console port.

Does anyone know the type of cable needed and the serial port settings to get into the CLI via the serial port?

Additionally is there any way to fix this without RMAing the device?

1 REPLY
New Member

Re: Trashed Firmware on WLC 2006

The following document will clearly explain you how to connect the WLC through console port.

http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080665cdf.shtml#basic

Aso, this document explains the software upgrade procedure

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00805f381f.shtml

171
Views
0
Helpful
1
Replies
CreatePlease to create content