Have you tried this method using the Mode Button to load a new IOS Image?
You can convert an access point from lightweight mode back to autonomous mode by loading a Cisco IOS Release that supports autonomous mode (Cisco IOS release 12.3(7)JA or earlier). If the access point is associated to a controller, you can use the controller to load the Cisco IOS release. If the access point is not associated to a controller, you can load the Cisco IOS release using TFTP.
Using a TFTP Server to Return to a Previous Release
Follow these steps to revert from LWAPP mode to autonomous mode by loading a Cisco IOS release using a TFTP server:
Step 1 The static IP address of the PC on which your TFTP server software runs should be between 10.0.0.2 and 10.0.0.30.
Step 2 Make sure that the PC contains the access point image file (such as c1200-k9w7-tar.122-15.JA.tar for a 1200 series access point) in the TFTP server folder and that the TFTP server is activated.
Step 3 Rename the access point image file in the TFTP server folder to c1200-k9w7-tar.default for a 1200 series access point, c1130-k9w7-tar.default for an 1130 series access point, and c1240-k9w7-tar.default for a 1240 series access point.
Step 4 Connect the PC to the access point using a Category 5 (CAT5) Ethernet cable.
Step 5 Disconnect power from the access point.
Step 6 Press and hold MODE while you reconnect power to the access point.
Step 7 Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds) and then release.
Step 8 Wait until the access point reboots, as indicated by all LEDs turning green followed by the Status LED blinking green.
Step 9 After the access point reboots, reconfigure it using the GUI or the CLI.
We are moving! Please use WLCCA Forum for updates and discussions
[toc:faq] Wireless LAN Controller (WLC) Config Analyzer Download Click
here to Download To request access, send an e-mail to
email@example.com. Please include your Cisco.com userna...
[toc:faq] IntroductionHere is the step by step process that we have to
take care of while converting LWAPP to IOS and then vice versa..LWAPP to
IOSThe hardware used = 1141 AP (make sure we are using the right
[toc:faq] Introduction AnyConnect Secure Mobility Client 3.0: Network
Access Manager & Profile Editor on Windows Summary Use the Cisco
AnyConnect Network Access Manager Profile Editor to build custom
profiles for the AnyConnect Secure Mobility Client. App...