Hello all, I am having trouble configuring a 1410 bridge to accept clients. I am running SW 12.3(7)JA3. I set the bridge to Root mode and assign basic settings but cannot connect with a client. I can see the SSID broadcasting. Any ideas?
Check if client sees the SSID of the bridge.If not adjust the channel number on the bridge. If SSID is broadcast check for the authentication type.Is it configured same on the bridge and the clients.Refer URL for configuring the bridge
Unfortunately, I have been informed by Cisco that the 1410 will NOT accept any clients. It only uses the UNII 3 band and is not capable of taking clients. Explains why I could see the broadcasted SSID, but not connect. Thanks for the reply.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...