Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trunking ASA 5505 and Cisco 1200 AP

Hi all,

I think I know the answer to my post but I would like a second opinion.

I am trying to trunk a Cisco 1200 AP to an ASA 5505. The AP must have a native VLAN on VLAN 1 according to this link:

http://www.cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43vlan.html#wp1038979

The ASA 5505 supports trunking but no native VLAN support.

http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/int5505.html#wp1057200 (see bottom of step 2).

Then I assume that if I want to do this, I'll have to put a switch in the middle, right?

The other option is to use a WLAN controller and tunnel all VLAN within the LWAPP tunnel.

Any other suggestions?

Thanks

Martin

3 REPLIES

Re: Trunking ASA 5505 and Cisco 1200 AP

Yup, stick a switch in the middle. A cheap 2950 will do the trick.

-brad

www.ccbootcamp.com

New Member

Re: Trunking ASA 5505 and Cisco 1200 AP

Is there any possible way or suggestion other than putting a switch in the middle to accomplish this setup (AP trunk to ASA)? Please advise. Thank you.

New Member

Re: Trunking ASA 5505 and Cisco 1200 AP

Are you not able to configure the vlan 1 option on the sub-interface?

interface GigabitEthernet0/2

speed 1000

duplex full

no nameif

no security-level

no ip address

!

interface GigabitEthernet0/2.1

vlan 1

nameif LWAP

security-level z

ip address x.x.x.x y.y.y.y

!

267
Views
0
Helpful
3
Replies
CreatePlease login to create content