Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Two Aironet APs

I have two Aironet 350 APs installed in our Enterprise wharehouse. I keep getting the error message "Network Bridge Loop: Received packet from Self destined to [AWC Mcast All]014096ffffff on port "fec0" on both AP. Is there some extra config that must be done when installing two APs when their signals overlap.

4 REPLIES
New Member

Re: Two Aironet APs

Are they on different frequencies. They should be. The clients will roam to the best AP

New Member

Re: Two Aironet APs

Thanks for the tip. Where do you set the frequency?

New Member

Re: Two Aironet APs

When the signals overlap, the AP's should be on different frequencies and have the same SSID. That eliminates interference in the overlap zone. In the US, stick to channels 1, 6 & 11.

Set the frequency in the AP Radio/Hardware page.

New Member

Re: Two Aironet APs

Thank you very much! They were both set to channel 6.

Thanks again!

194
Views
0
Helpful
4
Replies