Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Unable to enter "Conf T" on Cisco Aironet 1310

Hello Experts,

I have a question about Cisco Aironet 1310 AP, the problem I am getting is that I am unable to enter the conf t mode to configure the AP. I am not sure what could be the problem. I have IOS 12.3 running on it.

Please help

14 REPLIES

Re: Unable to enter "Conf T" on Cisco Aironet 1310

When you connected did you have to login?

Did you type "enable" prior to trying to type conf t?

Steve

Sent from Cisco Technical Support iPhone App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Re: Unable to enter "Conf T" on Cisco Aironet 1310

Hi Steve,

Thanks for your reply, I am consoled in and in enable mode, I had to put a password to get to enable mode.

Sent from Cisco Technical Support iPhone App

Silver

Re: Unable to enter "Conf T" on Cisco Aironet 1310

Hello,

you need to first type command enable and then it will ask for ht epassword if the enable password is set, once you are into it you can type the command configure terminal. This is how it all works.

New Member

Re: Unable to enter "Conf T" on Cisco Aironet 1310

Yes, I am in enable mode.

Sent from Cisco Technical Support iPhone App

Re: Unable to enter "Conf T" on Cisco Aironet 1310

do a show ver.  make sure your software is k9w7(aIOS) and not k9w8(CUWN)

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Re: Unable to enter "Conf T" on Cisco Aironet 1310

Hey Steve,

Its k9w8, this is what I see on sh ver

Copyright (c) 1986-2006 by Cisco Systems, Inc.

Compiled Mon 17-Jul-06 11:45 by alnguyen

ROM: Bootstrap program is C1310 boot loader

BOOTLDR: C1310 Boot Loader (C1310-BOOT-M) Version 12.3(2)JA4, RELEASE SOFTWARE (fc1)

AP1310-MASJID uptime is 1 week, 2 days, 9 hours, 38 minutes

System returned to ROM by power-on

System image file is "flash:/c1310-rcvk9w8-mx/c1310-rcvk9w8-mx"

cisco AIR-LAP1310G-A-K9    (PowerPCElvis) processor (revision B0) with 24566K/8192K bytes of memory.

Processor board ID FTX1536U060

PowerPCElvis CPU at 262Mhz, revision number 0x0950

Last reset from power-on

LWAPP image version 3.0.51.0

1 FastEthernet interface

Bronze

Re: Unable to enter "Conf T" on Cisco Aironet 1310

this means you are using a lightweighted AP and by default it does not support config mode.

Convert it to a k9w7 (aIOS) AP then you should be able to configure it.

Sent from Cisco Technical Support iPad App

New Member

Re: Unable to enter "Conf T" on Cisco Aironet 1310

Is there a way to configure it without converting the ISO? Like may be via web based interface?

Bronze

Re: Unable to enter "Conf T" on Cisco Aironet 1310

there is no need to enter config t mode in lightweighted ap... all config is done on wlc...

debug capwap console cli

above cmd will open config t mode.

Sent from Cisco Technical Support iPad App

New Member

Re: Unable to enter "Conf T" on Cisco Aironet 1310

We dont have a WLC yet. Can it be used as an inpedenpent AP? If so, should it be converted to a regular IOS to do that?

New Member

Re: Unable to enter "Conf T" on Cisco Aironet 1310

Ok let me check

Sent from Cisco Technical Support iPhone App

Cisco Employee

Re: Unable to enter "Conf T" on Cisco Aironet 1310

I think you are using LWAP mode and In this mode config T does not supported. Please check the same.

New Member

Re: Unable to enter "Conf T" on Cisco Aironet 1310

Could you please guide me to a document to convert it to an autonomous IOS

Sent from Cisco Technical Support iPhone App

Re: Unable to enter "Conf T" on Cisco Aironet 1310

Check this link out

https://learningnetwork.cisco.com/thread/14405

Sent from Cisco Technical Support iPhone App

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
1503
Views
3
Helpful
14
Replies
CreatePlease to create content