Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unable to specify different VLAN for WLAN, in H-REAP mode

I've decided to try to use an existing WLAN and have it working with a new AP in H-REAP mode.

-I've joined the AP to the remote controller, assigned it an IP, put it in H-REAP mode.

-I chose a WLAN, enabled local switching.  On the controller, this WLAN uses VLAN 222.

-I went into the AP, configured the native VLAN, that was fin.  However, when I try to edit the WLAN VLAN,  CAN NOT change it. It always goes back to default (222).

I verified the vlan exists on the switch, is routable, etc, the switch port is a member of that vlan, it is set as a trunk w/ 802.1q, etc.

Any ideas on what would cause this?


I am SOO close   Thanks!

1 REPLY
New Member

Re: Unable to specify different VLAN for WLAN, in H-REAP mode

Ladies and gentleman, does this make sense?

I am using WCS to try and configure this...and that is where I was having trouble.  When I pulled up the WLC directly and made the vlan mapping change, it saved and worked fine.  Those changes were reflected in WCS also.  A bug maybe?   This is old 4.2 stuff

253
Views
0
Helpful
1
Replies