Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Unknown client or device name

Hi Experts,

I have a standalone AP 1242AG with IOS Version 12.4(21a)JA1 configured with WPA v2 and AES encryption and would like see Client Names when i use the CLI command "#sh dot11 associations client".

Currently my command output is only showing Device = Unknown and Name = Blank, below output:

P#sh dot11 associations client

802.11 Client Stations on Dot11Radio0:

SSID [CasaRanch] :

MAC Address    IP address      Device        Name            Parent         State
001f.e170.6eed xxx.xxx.xx.xx  unknown       -               self           Assoc
4860.bcb9.d787 xxx.xxx.xx.xx unknown       -               self           Assoc

Is possible change this behavior to show Netbios client name at least ???

What commands are required or configuration change ???

Thank in advance.,.,.

Everyone's tags (3)
430
Views
0
Helpful
0
Replies