Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Unmonitor unused radio if in WLSE

I've about 20+ AP being monitored by WLSE, but nor all the AP radio interface are enabled, (some only the radio 1 and some radio 0 are enable), but the WLSE is displaying errors/faults for that.

Is there a way, not to monitor those unused radio interface ??

Thanks.

1 REPLY
Silver

Re: Unmonitor unused radio if in WLSE

Please try the SNMP connectivity tool and see if the sysObjectID is supported

http://cisco.com/en/US/products/sw/cscowork/ps3915/products_device_support_table09186a0080216263.html#wp20790

91
Views
0
Helpful
1
Replies