I can't reach one of the controllers on the wism after a downgrade..
controller erases its configuration everytime I reset the module, and i start to configure it again and when i finish, it saves and reboots the controller.. when i check at the 7600's CLI (sh wism module 3 controller 2 status) I've seen the configuratin i've made but "Operational Status of the Controller" is stacked at Keepalive, and I cant reach it. After I reboot the module and check it, all configuration is gone and Operational Status of the Controller:Oper-Up so when i connect the controller configuration wizard comes again..
dc#sh wism module 3 controller 2 status
WiSM Controller 2 in Slot 3 configured with auto-lag
Press ESC when the wlc is in the boot process and see what image the wlc is booting from. Also it looks like your management interface is set for dhcp and is not getting an IP address... since it is getting 169.254.1.1.
I think you got it Scott. If the management interface is dhcp and the 6500 is configured for a static address in the same network as the 2nd controller. I would assume he has a vlan set up for management of his wireless. The controller is never completely configured when the reboot occurs because it can't get a valid IP address from the management vlan. It thinks it has failed the setup wizard and reboots with the setup config. Just a theoretical thought process as I don't know this for sure.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...