I have WCS running at the version 6.0.132; would like to upgrade to latest version 6 available; downloaded software and started installation. At the point where installation should find the previous version, the messages says that there is none to find. The current installation is on D drive and installation wizard goes by default to C drive. If you follow the installation wizard there is step where you can choose installation directory but not sure why wizard did not find existing installation.
I would like to keep existing database and just perform upgrade - what your suggestions would be in this case?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...