Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

upgd an LWAPP 1130AP (4.2.130/4.2.176) to 6.0 and back down to 4.2.130

Greetings,

I'm about to upgrade the code on 2 WiSM WLC's from 4.2.130 to 4.2.176 and then to 6.0.182. Then move these 2 WLC's to a new mobility group which will be created as well. After creating the mobility groups, I plan on moving ONLY 4 -1130's from an existing mobility group over to the new mobility group.

Q1 - Is it best practice to have the 1130 LWAPP AP's join the 4.2.176 prior to joining the 6.0.182 or does it really matter?

Q2 - Also, should I attach the 1130's to the upgraded controllers prior to creating the new mobility goups or after ?

Q3 - Lastly, are there any caveats from downgrading an 1130 LWAPP AP from 6.0.182 back to 4.2.130?

Thanks

-RC

1 REPLY
Hall of Fame Super Gold

Re: upgd an LWAPP 1130AP (4.2.130/4.2.176) to 6.0 and back down

Hi Richard,

1.  Doesn't matter.
2.  After the upgrade. 
3.  Yes.  There's a significant chance of you loosing your configuration.  If I were you, wipe the config clean, downgrade the firmware and then re-configure.  This minimize the risk of some codes getting broken during the downgrade process.

248
Views
0
Helpful
1
Replies