Client scanners mod. DENSO))((AP1230 automous))((telnet to AS400
Mod. Denso BHT210BW, after 5 min of inactivity the client activates the standby mode, disable the radio.
The warehouseman press the button on the terminal activates the radio and read the activity sull'As400.
I upgrate the system to LWAPP mode.
This is the new scenario:
Client scanners mod. DENSO))((LAP1230-WLC2125-188.8.131.52))((telnet to AS400
The warehouseman press the button on the terminal activates the radio and read the activity sull'As400 but appears the message "not connecting with AS400", after 2, 5 minutes, the tool will unlock and everything is working properly.
Re: Upgrade autonomous to LWAPP -> client disconnects
I've always had issues with regards to scanners and them going into sleep mode or powering down the radio. The workaround was to set the devices to maximum performance or always on. Have you tried to set this in at least one scanner to see if that would solve your problem?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...