Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Upgrading an Autonomous AP to Lighweight AP remotely via CLI

 

Hello

I am trying to upgrade an AP with the following details from an Autonomous AP to Lightweight AP remotely via CLI as that is the only way I have access to the device.

sh inv
NAME: "AP1130", DESCR: "Cisco Aironet 1130 Series (IEEE 802.11a/g) Access Point"
PID: AIR-AP1131AG-E-K9 , VID: V06,

 

Version is

flash:/c1130-k9w7-mx.124-10b.JDA3/c1130-k9w7-mx.124-10b.JDA3

 

Is it possible to do it remotely via CLI? any process I need to follow?

 

Any advice will be most appreciated.

 

Thanks!

2 REPLIES
Hall of Fame Super Gold

Yes it can be done remotely

Yes it can be done remotely and EASILY.

 

First, go HERE and download the lightweight recovery file (the TAR file).   Next, load the TAR file into the AP using the command "archive download-sw tftp://<TFTP IP address>/filename.tar".  

 

Once the IOS is completely uploaded to the AP reboot the AP.  The AP will soon load the recovery image and all you have to do next is plug the AP to your LAN segment where your WLC is.

Cisco Employee

You may refer the below link

You may refer the below link for the upgrade :-

 

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp156967

 

54
Views
0
Helpful
2
Replies