Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
We have a 3Com switch sitting between a BBSM 5.3 with Service Pack2 and Cisco 1100 Access Point.
The users (Wireless and Wired) are browsing successfully without any problems.
We want to replace the 3Com with Cisco Catalyst 500 Express switch.
When we try to define the Cisco switch in the BBSM, we can not find it listed there.
This is a life network and we can?t migrate unless we make sure that everything will work smoothly.
Isn?t the 500 Switches supported by BBSM 5.3????
There are a few pre-requisites to have a switch interacting properly with BBSM. BBSM would work with every switch that is RFC 1493 compliant, and that can be managed via SNMP.