Users can get to internet through remote WiSM but not to corporate network
I am using a WiSM in a 6509 and have a handful of sites converted from Fat to LWAPP. All sites connected to Corp over T1 (IPSEC+GRE). The user gets on the network fine and can get to www.google.com and other Internet Sites. All web sties internal to the company never come up or take at least 3 minutes to come up.
WAN segment is a 10.163.11.0/24
Corporate office is 172.16.0.0/16
tracert works fine.. and telnet works fine.. but RDP, HTTP, Netbios and Citrix to the 172.16.0.0/16 network fails.
We are running 2 SSID's one is Protected and one is in our Guest network. Protected runs EAP-PEAP and auths fine.
I do have broadcast forwarding disabled and Peer to Peer blicking enabled.
Re: Users can get to internet through remote WiSM but not to cor
I had a similar issue with a WiSM in that I could not get to the Internet, unless I had an ACL with 'log' turned on. In the end it turned out to be a problem with a WS-X6548-GE-TX, in that it was dropping small packets. The Internet, via a proxy server and some other server where connected to this blade and once move (ultimately replaced with a new 6548) the problem went away. The ACL could then be removed.
There is a field notice out about the 6548, it also covers 6148.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...