We are building a 6 building campus and there is a need for wireless access throught the campus and out on the grounds. Since each building is a separate VTP domain with no layer 2 connectivity between them when a wireless user goes from building to building they will need to acquire a new IP address. Thus I am looking into using Mobile IP and had read about the Aironet's ability to proxy the Mobile IP stuff for the client so that the client doesn't have to have the software loaded on their machine. Is anybody using this? If so can you give me a few pointers on where to go to get more info on this.
Cisco, can you point me to more documentation on this? There doesn't seem to be much on the web site about this.
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...