Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Using WCS to dynamically assign WLC AP licenses

I heard from a Cisco sales rep that WCS could dynamically move AP licenses in the event that a WLC fails. For example, a client has 3 100 AP WLC's and all of them are at AP capacity. If one of them fails, WCS would move it's "AP licenses" to another controller(s). Is this possible or was this just another stretch claim from a sales person?

Thanks!

Tony

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Using WCS to dynamically assign WLC AP licenses

very interesting....

I was under the impression that the license files were stored on the WCS and that the WLC did not care about the license counts.

Regardless, if the WLC is at capacity, it cannot support anymore APs, license or not. If your client loses a WLC, he will have 100 APs out of service until a slot comes open on 1 of the other WLCs.

A rule of thumb we use, is to have the ability

to absorb all APs. For example, if you have 50 APs, it would require 2 4402 controllers (think redundancy) if the # of APs grow, we would add another controller to help absorb the extra or upgrade to 4404s or wisms

1 REPLY

Re: Using WCS to dynamically assign WLC AP licenses

very interesting....

I was under the impression that the license files were stored on the WCS and that the WLC did not care about the license counts.

Regardless, if the WLC is at capacity, it cannot support anymore APs, license or not. If your client loses a WLC, he will have 100 APs out of service until a slot comes open on 1 of the other WLCs.

A rule of thumb we use, is to have the ability

to absorb all APs. For example, if you have 50 APs, it would require 2 4402 controllers (think redundancy) if the # of APs grow, we would add another controller to help absorb the extra or upgrade to 4404s or wisms

169
Views
0
Helpful
1
Replies
CreatePlease to create content