Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Virtual WLC in LAB environment

Hi!

 

I have just installed a Virtual WLC at home for lab purpose. Now i want to connect one accesspoint to my wlc, but for now the WLC says "0 access points supported". 

 

Can i somehow still use the evaluation licens and connect a accesspoint to the wlc? 

/Lajja1234

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Hi Lajja,You have to enable

Hi Lajja,

You have to enable the evaluation license in order to allow the AP to join.

How to do it, please check here:

http://www.cisco.com/c/en/us/support/docs/wireless/virtual-wireless-controller/113677-virtual-wlan-dg-00.html

 

Hope it helps.

 

Regards

Dont forget to rate helpful posts

2 REPLIES
VIP Purple

Hi Lajja,You have to enable

Hi Lajja,

You have to enable the evaluation license in order to allow the AP to join.

How to do it, please check here:

http://www.cisco.com/c/en/us/support/docs/wireless/virtual-wireless-controller/113677-virtual-wlan-dg-00.html

 

Hope it helps.

 

Regards

Dont forget to rate helpful posts

VIP Purple

Also note that vWLC only

Also note that vWLC only support FlexConnect mode AP. So if you have local mode AP you need to convert it to FlexConnect mode.

HTH

Rasika

**** Pls rate all useful responses ****

414
Views
5
Helpful
2
Replies