Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VXWorks to IOS conversion Tool for 350 Bridges

I have been unable to find any information as to whether or not the VXWorks conversion tool with work on 350 Bridges. Anyone have any idea? Thanks

3 REPLIES
Cisco Employee

Re: VXWorks to IOS conversion Tool for 350 Bridges

Hi. Unfortunately, as far as 350's go, only a 350AP can be converted to IOS. A 350 Bridge or Work Group Bridge cannot be IOS. If your unit is a bridge or work group bridge then you will not be able to convert it, but there is no limitation regarding upgrading VxWorks to the latest version.

HTH,

-Joe

New Member

Re: VXWorks to IOS conversion Tool for 350 Bridges

Thank you for you input.

Also can a 350 AP be loaded with Bridge firmware to become a bridge?

Can a 350 non-root bridge communicate with a 1200 series root bridge?

Believe it or not I used to work with 350's.

; ) Thanks

Cisco Employee

Re: VXWorks to IOS conversion Tool for 350 Bridges

Hi.

A BR350 will act like a Bridge AND an AP at the same time, but simply trying to load bridge software on an AP will not turn it into a bridge.

An AP1200 can communicate with a BR350, but no VLAN's are supported in this configuration.

HTH,

-Joe

160
Views
0
Helpful
3
Replies