I have an AP(Cisco Lynksis Wireless G WAP54G) with one port (LAN) on the back, i have tried several time accessing the administration page but in vain. I reseted the AP (holding the reset button within 10 secondes) and try again to access through my internet brower but still having the same issue on accessing the admin page. Can someone help me to sort out this? The main target is to access the admin page and configure settings in order to amplify my signal in some offices away.
you can try to do a hard 30/30/30 reset, just in case. Hold the reset button for 30 secs, then without release the button pull out the plug for another 30 secs and then put the plug back in without release the reset button for another 30 secs and see if it works.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...