Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

WCS 5.1.64.0 and Exclusion Area in planner mode

I'm noticing in WCS 5.1.64.0 that I can set a exclusion area, and the planner will put a AP in that area. Does planner not pay attention to exclusion areas?

1 REPLY
Community Member

Re: WCS 5.1.64.0 and Exclusion Area in planner mode

Have you resynchronised the network plan with your location appliance or MSE after creating the inclusion zone. If you have and that doesn't work it may be worth unassigning the network plan from the Loc Ap, resynching with WCSand then assigning the network planback to the Loc ap and resynch.

Good look

146
Views
0
Helpful
1
Replies
CreatePlease to create content