I am converting standalone cisco1231AP to LWAPP. In the process, the conversion is always successfull. Run the audit on WCS, refresh values from Controller and restore values from Controller... The process after that involves us running few lightweight templates. Now, with the newly converted AP, I used to be able to see thm on both WCS and WLC. However, I dont see the new APs in WLC anymore. Besides checking the SNMP settings for sync, what else should I check?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...