Hi, we upgraded from WCS 18.104.22.168 to 22.214.171.124 to make use of the enhancements to the DB engine.
However, we are faced with a problem when we run the AP Summary report. We customized the report to be very basic as seen in the attached image. We only need the AP Name and Ethernet MAC address to be generated on a daily basis.
I tried the following workarounds and both of them failed to generate the report successfully:
1. Schedule the report to run on a daily basis. On the "saved reports" page, WCS displays that the report run was successful (green tick square) but there is no csv file to download. Browsing to the folder where the csv file should have been saved, I found an empty file.
2. Disable scheduling. I saved the report as non-scheduled then I clicked on "Run Now", WCS displayeded the following error:
The specified criteria did not match any data for the report.
Make sure that the following background tasks are running:
Browsing to the specified task, I found it running successfully.
Is this a reported bug? How can we overcome this putting in mind that this report used to work with the previous version 126.96.36.199
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...