Good day, I am trying to setup Aero Scout Exciters (Chokepoints) to map RFID tags (AeroScount Tag T2) to a specified map when passing the chokepoint. I was told by AreoScout that we could use the Exciters to map tags to a specific floor to help correct floor separation issue we are having. I can see in WCS the time/date stamp when the Tag registers with the exciter. The issue is that once the Tag leaves the range of the exciter it doesn't stay on the mapped floor.
Any ideas on possible issue or configuration that I am missing to correct this issue?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...