Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WCS Client Count Report without Map

I have a large campus with a large number of odd shaped buildings for which we do not have accurate floorplans and we need to run historical reports for the client count per AP however as far as I can see this is not possible unless I create maps and floorplans of the site.

Is there any way to get the client count per AP on a historical basis without the need to create maps and floorplans of the whole site.

1 REPLY
Hall of Fame Super Silver

Re: WCS Client Count Report without Map

It's been a while since using WCS, but I've always used maps. I would just suggest you add a fake map even if it's a box and place the AP's on the appropriate floor if possible. An old map is better than no map to be honest. I have had to take the emergency floor plans (old as heck) and copy that or take a picture on my phone and use that on WCS.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
163
Views
0
Helpful
1
Replies