I am having trouble performing "calibration". I created a model for the 10th floor, walked around collected my data points, calibrated the floor and applied model to the 10th floor map. That worked great. Next, I tried to do the same on the another floor (the floor layout is different). But when I get to the part to "add data points" and select the appropriate floor I get a pop up error:
Windows Internet Explorer
Error(s): You must correct the following error(s) before proceeding:
Error: Object "CalibrationModel#1734276" does not exist.
It does this to every remaining floor I try to calibrate. Any thoughts??
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...