I have a 4402 that was in demo status in my lab. I then moved it into production. While there were only minor changes such as IP, DNS, hostname, etc. to the 2710, WCS is a fresh install on another machine. When I attempt to synchronize the same 2710 with the new WCS, I get the following error:
A similar element was found in the Server. Please synchronize again to remove any disparities.
I have synchronized several times without success. Any ideas? I'm not open to re-doing the setup on either, so hopefully someone knows of a file on the 2710 that stores the information the error makes reference to and I can just erase it or overwrite it.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...