When setting up a building make sure it has enough square footage to accommodate the floor areas or you will receive a error stating the the floor area exceeds the area of the building. The building square footage is actually the drawing square footage. Areas outside of the building but in the jpg are included in the calculations. The best way is to over estimate on the building then scale the floor correctly from a know distance on the drawing.
When I put my maps in, I get the map, however accurate it is, from our Estates Department. They rarely have a scale or measurements on them so I go and find the building in Google Earth (GE), rotate the building in there so that it is in the same orientation and then use the measuring tool in GE to get the measurements in metres.
It might not be the most scientific approach, but it's not that bad when you have nothing to go on.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...