Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WCS Maps

I bring in an autocad drawing to png and type in the Horizontal & Vertical dims. When I go to look at the maps to place APs, the map is all squished. When I try to alter the dimensions I tells me I can't be bigger then the parent building. Here are my maps stats:

Building: H 299.10 ft V 183 ft

Basement is:H 299.10 ft V 78.6 ft

Floor 1 is:H 299.10 ft V 183 ft

Floor 2 is:H 299.10 gt V 78.6 ft

Floor 3 is:H 31 ft V 25 ft

what am I doing wrong?

  • Other Wireless - Mobility Subjects
5 REPLIES

Re: WCS Maps

Try making the floor heights smaller than the building height.

Also,

is the total combined height basement, f1 & f2 greater than building height?

New Member

Re: WCS Maps

No the building height is not higher then then all floors combined. Should it be?

Also, The text that labels each room with a number is blurred. Its very clear in the original DWG file. Is there a way around that?

Re: WCS Maps

I would think so...

I'm not sure about the clarity of imported DWG files. I typically import jpegs.

New Member

Re: WCS Maps

I have rooms in my map that have different ceiling heights. One room will be 8 ft and another 20.

When entering in the height should I go with the highest room or what ever the majority of rooms are?

Silver

Re: WCS Maps

Yes, this is frustrating. Here's what I've done to make things work:

First, set the building dimensions to something arbitrarily large, like 5000 by 5000. Now you can set your floors up without worrying about building dimensions.

Once your floors are done, then try to set the building dimensions to something arbitrarily small, like 10' by 10'. This will return an error and list all the actual dimensions of the floors. Then you can just use that info to figure out what the building dimensions actually need to be. (Note that the order of dimensions in the error message is reversed from how you will enter it on the setup screen.)

162
Views
0
Helpful
5
Replies
This widget could not be displayed.