Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Web GUI not working on 2106 Controller after Management IP Change

After IP change unable to access Web GUI with new IP,  ran  config network webmode enable and config network secureweb enable neither command has any effect.

4 REPLIES

Web GUI not working on 2106 Controller after Management IP Chang

Did you just change the IP 20.4 to 20.8, or did you change the VLAN as well?

IF you changed the VLAN, make sure you update the native VLAN on the switchport if you have it set to untagged.

Finally, did you reboot?

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered

Web GUI not working on 2106 Controller after Management IP Chang

Just a ip address change, vlan remains the same,

rebooted muliple times once with web disabled and others web enabled, still nothing

device always pings

Web GUI not working on 2106 Controller after Management IP Chang

Update: I reentered the managment IP infomation as before and this time the web GUI started working

Web GUI not working on 2106 Controller after Management IP Chang

you put in the old information or rewrote the new information?

with the new information, if you do a show arp, does it show the correct information?

Can you post the output from show interface summary, both new and old IPs?

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
231
Views
0
Helpful
4
Replies