I'm trying connect to the wlan with a linux station, but I can't. It associates (I can see in the AP with "show dot11 associations), but never get the IP. It seems to the a problem with the authentication.
I try the same configuration, with Linksys AP, and it works fine.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...