I try to configure a WGB in autonomous mode to connect to a lightweight access-point. I followed the cisco paper about it and my wgb associate well to the AP on the asked SSID. From the wgb i can ping stations behind the lightweigth access point so the association is OK. My problem is wired stations behind the WGB cannont ping.
The ap use H-REAP mode with mutli-ssid. I want wgb for only one ssid.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...