i need to connect two building using one AIR-AP1230 and one AIR-BR1310G,the problem is that the AP have some SSID configured (voice,data,voice wirlesse,data wireless) and authentication LEAP.The bridge must be a workgroup bridge to connect the wired/wireless user to the domain.I tried to configure the AP as root and the second as WGB but the Fastethernet is disabled.
Can someone post the settings to do it, or explain how to do it?
To connect the building using a AP and a Bridge, you have to configure the AP as a Root Bridge and the Bridge to be a non-root. In any point to point wireless link you need to have a root bridge and a non-root bridge. Since you have the AP on one side you have to configure the AP as a bridge (as a root bridge). For connecting the wired clients to the wireless domain, you have to use a WGB or a AP can be configured as a WGB.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...