Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WGB350 - Unable to determine radio type

Hi,

My WGB350 is showing the following message:

"0:01:10 S Unable to determine radio type !"

It allways happens a few minutes after power on the radio. I updated the firmware to 8.85 but the same problem persists.

When it happens, the telnet header shows

WGB340 and the mac address is changed to a crazy value. Also, some options desapears from menu.

Thanks.

Luciano Lima

1 REPLY
Anonymous
N/A

Re: WGB350 - Unable to determine radio type

When the unit boots up, it checks it's hardware. The radio is also a part of hardware. The actual radio can be configured for different countries and is programmed a specific way. "Unable to determine radio type" is a FATAL error if the unit is not able to determine the radio is for which location.So it fails the POST with the above error.

101
Views
0
Helpful
1
Replies