What cause the ping lost

[eva-dhc]

I use aironet br342 with 2.4dBi dipole as access-point.

I found that when I use ping -t with a pc ,

over 10 packets time out from time to time , while the signal noise rate is still quite good .

Further more , I found that when I open about clients

the speed of the network became rather slow ,the collision

became unacceptable.

Please be kind to help me, it is urgent.

[derwin]

Little hard to say from the information here but.

Does the client stay associated ? The log of the BR342 will help you check this

On the BR342 do you see many CRC errors ? or radio hold offs

Have you tried another channel ?

What firmware version is on the BR342 ?

What NDIS ACU and firmware version are you using on the clients ?

Are you trying to ping the BR342 or a PC behind the BR342 ?

I hope this gives you a few things to look at

[nzamanzadeh]

Make sure your ethernet connection is set to "autonegotiate" on both sides or manually set to whatever you decide: 100 Mbps/Full Duplex, 10 Mbps/Half Duplex, etc.