Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

What cause the ping lost

I use aironet br342 with 2.4dBi dipole as access-point.

I found that when I use ping -t with a pc ,

over 10 packets time out from time to time , while the signal noise rate is still quite good .

Further more , I found that when I open about clients

the speed of the network became rather slow ,the collision

became unacceptable.

Please be kind to help me, it is urgent.

2 REPLIES
Cisco Employee

Re: What cause the ping lost

Little hard to say from the information here but.

Does the client stay associated ? The log of the BR342 will help you check this

On the BR342 do you see many CRC errors ? or radio hold offs

Have you tried another channel ?

What firmware version is on the BR342 ?

What NDIS ACU and firmware version are you using on the clients ?

Are you trying to ping the BR342 or a PC behind the BR342 ?

I hope this gives you a few things to look at

New Member

Re: What cause the ping lost

Make sure your ethernet connection is set to "autonegotiate" on both sides or manually set to whatever you decide: 100 Mbps/Full Duplex, 10 Mbps/Half Duplex, etc.

285
Views
0
Helpful
2
Replies
CreatePlease login to create content