I have 3 wism's and on one of the controllers I have mesh code on it becuase we have a mesh network we are running. I was going to put the mesh code on another controller on a different wism so if the controller the mesh network was one ever failed, it would fail over to the other controller with mesh code. Then I started to wonder if there any reasons a person shouldn't be able to run the mesh code on all the controllers even if you don't have a mesh network running off of it. Basically just wondering if there is any type of good practice or bad practice as far as doing this or if i should just stick to non-mesh code on the controllers not running a mesh network. Any thoughts or suggestions would be appreciated. Thanks.
I have heard on the grapevine that the mesh & non-mesh trains will merge in a release in the not too distant future. If you do not need a feature or bug fix from a rev above what you are running, it may be best to wait.
Eric is right here. Here is another little tidbit of info. MESH APs will also work on 4.1.185 and early versions of 4.2 indoor code versions. The MIBs for the APs are removed from 5x code until the trains remerge later this year.
I have 18.104.22.168 on one of the controllers and I have 22.214.171.124M on the other controller, but on the other 2 wisms i'm running 126.96.36.199 and I just wanted to get those two a little up to speed since you can't download that version of code anymore. Also wanted to put 188.8.131.52M on another controller just for redundancy purposes. Thats when I started thinking about putting it on all the controllers.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...