Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Why ISR 881w only support 802.11n 20MHz width ?

As I know , 881w can support both 20MHz and 40MHz , but after enter the wireless module configuration , I only find 20MHz option under dot11radio0 interface's channel width setting , and can not find 40-above and 40-low two options , WHY?

My 881w wireless module is AP802 , version is below ,

Cisco IOS Software, AP802 Software (AP802-K9W7-M), Version 12.4(25d)JAX1, RELEASE SOFTWARE (fc4)

I'm looking forward to your response . Thanks !

Harry

Everyone's tags (1)
2 REPLIES
Cisco Employee

Hi , Channel bonding is not

Hi ,

 

Channel bonding is not supported on 802.11b/g i.e dot11radio0 because there are already very less number of non-overlapping channels.

It should be there under 5 GHz/dot11radio1 to select 40MHz.

 

Regards

Dhiresh

 

 

New Member

Get it ! BTW , do you know

Get it ! BTW , do you know 881w can support WDS feature ? Thanks !

65
Views
0
Helpful
2
Replies
CreatePlease to create content