will enabling flexconnect on WLAN SSID page disconnect current clients?
I have a WLAN SSID that currently does not have flexconnect enabled. I am preparing to deploy some APs at a remote site and will use local switching there to save WAN bandwidth. If I enable flexconnect on the WLAN and not the APs, will clients currently connected to the SSID be disconnected?
When you modify any WLAN settings momentarily clients get disrupted (in CLI you have to shut the WLAN first before modify any settings. In GUI when you do config changes on WLAN same thing happen in background)
That WLAN settings (FlexConnect Local Switching) applicable to "FlexConnect mode AP". So unless you change branch AP to that mode & properly configured vlan mapping there is no effect on that feature.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...