WIRELESS 4400 CONTROLLER WPA-2

[edwards]

Hi Wireless Lan controller 4400 the documnetation on this product is awfull . I am trying to configure wpa-2 using 802.1x authentication or leap is this possable as for web interface cannot find were you set authentication type. if wpa-2 uses a particular type what is it. Probably a very dumb question but these option apper to be availble on all airnet products

[mchin345]

Web authentication enhancements extend the total number of characters on Web authorization customization to 500 characters. The user can also use a "submit" button instead of a full user name / password challenge. A third enhancement allows Wi-Fi Protected Access/Pre-Shared Key (WPA/PSK) and WPA2/PSK to work with Web authentication. These enhancements provide more flexibility in deploying wireless networks with Web authentication.

Wireless LAN Controllers supported: Cisco 2000, 4100, and 4400 Series

Access points supported: Cisco Aironet 1010 and 1020 Series lightweight access points

http://www.cisco.com/en/US/products/ps6366/prod_bulletin0900aecd802d2742.html

[j.metzger]

In the controller, you navigate to the WLAN page, where you name the SSID etc. On the upper right of the page is the L2 security options drop down box, below that the L3 options.

[Guillaume BARBEROT]

On the SSID page : go to L2 and select WPA-2

at the bottom of the page : verify that the box Passphrase is NOT checked and voila it's WPA-2+802.1X

since it's not WPA-2+PSK(passphrase)

GB

[edwards]

THANKS

WILL TRY

eDDIE