Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Wireless Bridge problem

Goodday,

I have a 2 Aironet BR2040E working fine over 18km.

I'm upgrading to the Cisco BR350 , using the existing antennas.Which is 23dbi Grid antennas, with 10m low loss cable between antenna and bridge.

The Cisco bridges do not associate.

The cisco bridges however do work over a short distance, but not over 18km.

One is setup as root and the other as a nonroot.

The SSIDs are the same.

I have tried the different data rates and still not working.

On the old aironet bridges, the km needed to be specified.

Do I need to specify the km on the Cisco Bridges?

Any suggestions ?

regds

2 REPLIES

Re: Wireless Bridge problem

Yes you have the configure the km on the Bridge:

http://www.cisco.com/en/US/products/hw/wireless/ps458/products_configuration_guide_chapter09186a008007f77f.html#97015

Configure it under: Setup /Root Radio Advanced Page

regards Bernhard

New Member

Re: Wireless Bridge problem

Hello,

Thanks, Its working, one more question.

I have configured it for 5.5Mbps,

Where can I view the data rates that its setup for.

regds

Johnny

219
Views
0
Helpful
2
Replies