Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

wireless bridge with 2602 and 1262

I have been tring to build a bridge with a 1262 on one end a 2602 on the other and not having any luck connecting. The 2602 replaced a damaged 1262. I only use the A radio for the bridge. Any suggestions on the config?

3 REPLIES
VIP Purple

Hi,please check these configs

Hi,

please check these configs:

https://supportforums.cisco.com/document/61936/autonomous-ap-and-bridge-basic-configuration-template

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/68087-bridges-pt-to-pt.html

 

Hope it helps.

 

Regards

Dont forget to rate helpful posts

Hall of Fame Super Silver

You should be able to use

You should be able to use your old configuration, there might be some differences depending on the code you were running, but it should work.

-Scott
*** Please rate helpful posts ***
VIP Purple

Pls attach two AP

Pls attach two AP configurations to check 

Rasika

151
Views
0
Helpful
3
Replies
CreatePlease to create content